Replace your furnace, heat pump and water heater together, designed as one system and installed by one team, with full coverage for your mechanical room for the next 10 years. For homes in Abbotsford, Chilliwack and Mission.
In many Fraser Valley homes built in the 1990s and 2000s, the furnace, air conditioner and hot water tank were installed at the same time. That means they tend to wear out at the same time too. Replace them one by one and you pay for three service calls, three sets of permits and venting work three times, often with equipment that doesn’t quite match.
The Full Mechanical Room Upgrade replaces them in one planned project. We design the heating, cooling and hot water together, so the venting, gas lines, ductwork and controls fit cleanly in your mechanical room and work as one system.
One project, one crew and one set of permits costs less than three separate replacements over a few years.
The furnace blower, heat pump coil and thermostat are matched, so the system reaches its rated efficiency.
When the furnace and water heater move off the old chimney together, there’s no “orphaned” water heater left venting into an oversized flue.
A wall-mounted tankless water heater frees up floor space in tight mechanical rooms and basements.
One company is responsible for everything in the room, for the next 10 years.
The two appliances share a gas line and often a vent, so replacing them together lets us size the gas line for both, vent each one correctly and leave the room laid out for easy service. It also means one shutdown, one inspection and no second visit a year later when the other one fails.
If your gas furnace is 15 years or older, the furnace and heat pump portion can be set up to qualify for FortisBC’s dual fuel rebate.
If only one piece needs replacing, you may be better off with a single service. Replacing your furnace and hot water tank only? We can quote that too. Learn more
Every upgrade comes with 10 years of coverage for the equipment we install. [O2 to confirm and fill in: what’s covered (parts, labour or both), any annual maintenance requirement, whether coverage transfers if the home is sold, and what isn’t covered.]
Manufacturer warranties on furnaces, heat pumps and water heaters usually cover parts only, and often need registering within a set time. We register every unit for you.
We look at your furnace, AC, water heater, venting, gas line, ductwork and electrical panel.
A room-by-room load calculation, hot water sizing for your household and a layout for the mechanical room.
Every component, the venting and gas work, permits, the coverage terms and any rebate, line by line.
Usually two to three days. You’ll have heat and hot water back each evening wherever possible.
We test every appliance, set the thermostat and book the gas and electrical inspections.
A walkthrough of the new system, warranty registration and your coverage documents.
What changes the price: the size of your home, equipment efficiency, the length of new venting, gas line upgrades, ductwork changes and electrical panel capacity. Financing may be available [O2 to confirm].
Usually two to three days, depending on venting, gas line and ductwork changes.
Only for parts of the installation days. We plan the work so you have heat and hot water back each evening wherever possible.
The furnace and heat pump portion can qualify for FortisBC’s dual fuel rebate if your gas furnace is 15 years or older. Some heat pump water heaters may qualify for other rebates. We check at the assessment.
[O2 to confirm: parts and labour, maintenance conditions, transferability.]
Yes. We’ll recommend what suits your household, but the choice is yours.
Yes. We offer it across Abbotsford, Chilliwack and Mission.
Book a free in-home assessment and we’ll show you the design, the cost and the coverage, with no obligation. Prefer to talk first? Call 604-619-0202.
